Fingerboard Inlay

I did a little more neck shaping and sanding, then attached the necks to the guitar bodies. After checking to insure the correct neck angle at the bridge position, I flattened the fingerboards and then measured and marked the centers of the frets that would have inlays. I used 6mm abalone dots from Stew-Mac, but didn’t have enough for both guitars, so I had to order a few more. They were placed by using a 6mm drill bit and then adding a few drops of thin CA glue. Once this was dry I re-flattened the fingerboard. I also placed side dots using the same technique.

JT fingerboard inlay 1.jpg
JT fingerboard inlay 2.jpg
JT fingerboard inlay 3.jpg